How To Set Up Tape Gun

Download Commodity

Download Commodity

Tape dispensers make packaging boxes easy and efficient. Information technology's important to learn how to properly employ a tape dispenser because shipping companies will send back packages that are not taped well. It can exist a bit catchy to load record into a dispenser, but in one case everything is gear up up the dispenser will save you tons of time!

1. 1

   Locate the end of your roll of tape. If you lot're loading a new roll, the end should be conspicuously marked. If you're working with a used roll, run a fingernail around the tape to feel for where the end is. Pull 0.25–0.five inches (0.64–ane.27 cm) of tape and fold information technology back on the roll.^[1]

   • Folding the tape back on itself simulates what the stop of a new roll of tape looks like.

2. 2

   Slide the record onto the spindle with the viscid side facing down. The tape dispenser handle should be to your right and the non-agglutinative side of the tape must be facing up. Take the end of the tape coil facing the roller and cutting blade.

   • If yous're having trouble putting the roll of tape on the spindle, lay the dispenser downward on a flat, stable surface to brand things easier.

   Ad

3. iii

   Thread the terminate of the tape ringlet between the roller and guide. There is a small slot in between the dispenser roller and the metal or plastic guide. To give yourself enough of room to thread the record through, hold the guide open past pressing downwards on the tab just beneath it.^[two]

   • Recall to check if the sticky role of the record is facing downwardly. If information technology'south not, it will stick to the dispenser roller.

4. iv

   Pull the tape up so that it goes over the serrated blade. To avoid cut yourself on the blade, pull the tape 1–2 inches (ii.5–5.1 cm) above it. Then, pull the tape back against the cutting border to brand a swell, even cut.^[three]

   • Throw away the tape that gets cut off past the blade.

Advertisement

1. 1

   Exam the dispenser'due south tension by rolling a small corporeality of tape out. Use an old box for this trial run. Cut the tape with the serrated blade subsequently rolling out about 5 inches (xiii cm) of it. You are looking to see if the tape unwinds smoothly and sticks to the box correctly.^[four]

   • Do not exam your dispenser on packages you desire to tape up. Await until you know the dispenser is properly loaded and adjusted before y'all showtime working with it for real.

2. 2

   Tighten the nut on the spindle clockwise to increase the tension. The nut is in the centre of the spindle and lets you accommodate the tension of the dispenser. If the tension is as well loose, the record might non wrap tightly plenty effectually the packaging to seal it properly.^[5]

   • If the spindle is likewise loose, you could end up using more record than you had in mind.

3. 3

   Loosen the nut counterclockwise to decrease the tension. If you find yourself pulling actually hard to whorl the record out, information technology might be considering the spindle is besides tight. If there is too much tension, the tape volition not curlicue evenly over your packaging or attach to the box the fashion you want it to.^[6]

   • Keep tightening and loosening the nut until yous tin smoothly roll out the tape without using excessive force.

Advertisement

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Advertisement

Thanks for submitting a tip for review!

Virtually This Commodity

Thank you to all authors for creating a page that has been read 55,855 times.

Did this article help y'all?

Source: https://www.wikihow.com/Load-a-Packing-Tape-Dispenser

Share this post